NYCD
New York Cycle Department

3D printed accessories for the urban cyclist

http://www.shapeways.com/shops/NYCD
Approved by NYCD
3D Printed Bicycle Bottle Fender Mount

Design by MichaelMueller
This 3d printed mount works with most plastic bottles, like Coke, Evian ect. You can just clip it on your bike - no glue or screws needed! I’ve used a bottle which I’ve cut before. Technical, there is no need to halve it but it looks better this way and it’s done easily. This bottle-fender-mount works nice on old steel bike racing frames. The diameter of the tube should be about 29 mm (1.14 inch). Please check the pictures above to see if it’s comparable to your bike. 
  1. Approved by NYCD

    3D Printed Bicycle Bottle Fender Mount

    Design by MichaelMueller

    This 3d printed mount works with most plastic bottles, like Coke, Evian ect. You can just clip it on your bike - no glue or screws needed! 
    I’ve used a bottle which I’ve cut before. Technical, there is no need to halve it but it looks better this way and it’s done easily. 

    This bottle-fender-mount works nice on old steel bike racing frames. The diameter of the tube should be about 29 mm (1.14 inch). Please check the pictures above to see if it’s comparable to your bike. 

  1. 76 notesTimestamp: Wednesday 2013/01/16 21:24:56Source: shapeways.combikefixie3d printshapewaysdesignindustrial designDIYlasersurbanNYCD
  1. david-64 reblogged this from nycd
  2. wafflehousecaravan reblogged this from nycd
  3. freakspotting reblogged this from nycd
  4. fung2037 reblogged this from nycd
  5. jesusescuderoilustra reblogged this from nycd
  6. natmiranda reblogged this from yzfrob27
  7. dannyscottie reblogged this from shapeways and added:
    Such a good idea :)
  8. yzfrob27 reblogged this from shapeways
  9. superandreaa reblogged this from shapeways and added:
    3D Printed Bicycle Bottle Fender Mount
  10. noconspiracytolerated reblogged this from veneziafixed
  11. veneziafixed reblogged this from nycd and added:
    Non ci vuole un genio ma una idea geniale
  12. jamesboardwell reblogged this from shapeways and added:
    My favourite 3D printed thing so far. Joining things up. Making things work. Adapting to our everyday needs rather than...
  13. twitchyturtle reblogged this from shapeways
  14. hellz-equator reblogged this from nycd
  15. ffa-mrdog reblogged this from shapeways